Take your Ford Transit further into the backcountry with confidence. This skid plate protects several vital engine components under the front of the 3.5L Ecoboost and 3.2L Duratorq equipped Ford Transits. The intercooler, intercooler piping and engine oil pan are all protected with this skid plate constructed of 1/8” high strength steel and powder coated with a durable, textured black finish. 100% bolt on with simple hand tools, minor drilling and plastic trimming. This skid plate also integrates with the Van Compass Transit Front Winch / Hitch Mount and it is easily removable for engine oil service. All hardware is provided for installation.
Add protection and peace of mind while exploring in the back country with the Van Compass rear differential skid plate. Loss of gear oil due to a cracked housing or leaking cover can be catastrophic to the rear differential. This skid plate protects the driveshaft u-joints, cast iron differential center section and lower portion of the thin sheet metal differential cover. Constructed from 3/16" steel and powder coated for corrosion resistance to provide a strong, smooth surface to slide over obstacles on the trail. The skid system bolts on in minutes with simple hand tools. Detailed instructions and all necessary hardware is included. Gear oil changes can still easily be performed without skid plate removal.
*COMPATIBLE WITH 2500 MODELS ONLY
The bolt-on Striker 4x4 Sprinter 2.0” suspension lift system provides clearance for larger tires and offers additional ground clearance under the van. Additional traction from larger tires and ground clearance helps to avoid obstacles on the trail to your remote campsite.
The Striker system retains the stock vehicle suspension geometry, payload rating and ride quality. All of the suspension lift system components are constructed of high quality materials here in the USA and are powder coated for durability and corrosion resistance.
With this lift kit, 315/75/16 (35”) tires can be fitted with the following conditions met:
- Removal of the front mudflaps
- Slight trimming of the rear of the front fender
- Trimming of the front bumper and front inner fender well liner.
- Minimum of a 9/16” (14mm) wheel spacer be installed on factory steel wheels with 54mm of offset or any other wheel that has comparable offset. This is for tire clearance between the inside of the tire and the strut and rear inner fender. ** Sold separately
- Note; this could be omitted with an additional 9/16” (14mm) offset and aftermarket wheels.
4x4 Sprinter Rocker Guards now available for 144" Sprinters!
Add function and style to your 4x4 Sprinter with a set of Van Compass™ Rocker Guards. The rocker guards create a 4" wide step to make getting in and out of your van more convenient. The robust design offers body protection and vehicle lifting points for on and off-road travel. Designed for maximum strength and ground clearance. The main steps are constructed from 1/8" steel. They are attached to the pinch seam with stainless steel hardware. Frame mounts are constructed from 3/16" steel and are attached in three locations to the vehicle's chassis. The front and rear vehicle lift points have integrated Hi-Lift jack slots to make off-road recovery or flat tire changes go safely. The middle mount has a flat portion for floor jack or bottle jack lifting. Drilling of holes at the pinch seam and under body gussets are required for installation.INCLUDED COMPONENTS:
- 3/16" Steel - Front, Middle and Rear Frame Mounts - Matte Black Textured Powder Coat Finish
- 1/8" Steel - Steps - Matte Black Textured Powder Coat Finish
- Stainless Steel Van Compass Logo Anti-Slip pads
- Stainless Steel Mounting Hardware